Western Branch Diesel Charleston Wv
If that isn't the case, I'll be adding an external battery pack to make up for the lack of internal charge circuit. Once the silicone boot is loose the the bottom, pry upwards from below the USB port and remove the silicone sort of like a sock, where the atomizer connection is the toe. When removed however, the battery is completely dead and the Puffco shows no signs of life. The teardown video is up on Youtube now: Step by Step Instructions: How to Open a Puffco Peak. My puffco wont heat up, instead it blinks 5 times, on whichever heat setting i have it on. Puffco peak short circuit fix video. Step 2: Pry the Shiny Metal Piece Upwards.
This faulty Puffco Peak vaporizer came into my possession within the last few weeks, via a friend of mine. What's Wrong with My Puffco Peak? The Puffco lights up, and indicates it's taking a charge when plugged in to USB. This can be removed as one whole piece, or disassembled and removed piece by piece.
It will lift off, and may require a twisting motion or a small amount of heat if it feels stuck. Using your thumbs, press outwards from the center on the base of the Puffco Peak. Ideally, finding out which component has failed; and swapping it for a working one is best – but my electronics skills are limited. 5v to the battery connection leads – the battery charges and holds its charge. The adhesive is fairly strong, and so some force is required to remove this piece. Place your fingers above the USB port where the shiny material and silicone meet and pry upwards on the shiny metal/plastic piece that surrounds the Puffco Peak. I just needed to get inside and start probing around with my multimeter. Step 3: Remove the Silicone Boot. That's it, your Puffco Peak is open before you. Puffco peak short circuit fix free. 4v battery pack – unless there were a buck converter somewhere on the battery pack I have yet to find. Use your fingers or a pry tool to peel the metal disc off of the bottom of the plastic Puffco Peak base. Use a screwdriver set like this one from Amazon to remove the three screws holding the plastic assembly together. I still have some detective work to do to determine why my Puffco Peak doesn't charge. In my case – I did some poking around with a multimeter and determined that my battery was not putting out a high enough voltage.
Step 6: Open and Inspect. We're starting off with a standard Puffco Peak base – glass removed. If anyone has input, questions or ideas – I would love to hear them in the comments below or on the Youtube video linked above. Let's assume you don't need a hand in figuring out how to remove the glass from your puffco. Step 1: Remove the Atomizer & Surrounding Components. I took it apart and cleaned the whole thing pretty well, i thought that would at least solve the connection issue, but it didnt seem to fix it): any tips or any help will be appreciated! These devices are simple, and with that in mind; there shouldn't be too many ways for the device to fail. Puffco peak short circuit fix how to. The silicone will lift out from under the shiny metal base of the Puffco. If you have done this before it makes sense, otherwise: read on.
I assume that this is the case, because when I apply 7. I suspect that there is an onboard boost converter that steps USB voltage up to above 7v, and it is defective. 5v – too low to charge a 7. Begin the disassembly process by removing the atomizer, bucket, and surrounding components. It should lift right out. Note: In my video, I perform step 5 before step 4 – and it really doesn't matter in the end, but I feel it's easier in this order.
Step 5: Unscrew 3 Security Screws. The first piece to be removed is a silicone and ceramic ring. Step 4: Pry the Metal Base Off. Do not force this out.
You may use a guitar pick or some other soft plastic prying tool to start the job if your fingers can't get in there.